Cleaning the outside of your windows removes dirt, grime, and hard water spots, making your home look brighter and extending the life of the glass. This guide covers the tools, technique, and order of work to get streak-free results without a professional service. Before you start, check the weather forecast—choose a cloudy, calm day, and avoid direct sunlight, which dries soap too fast and causes streaks.
What You’ll Need
- Squeegee (with a rubber blade, ideally 12–18 inches wide)
- Microfiber cloths or lint-free rags
- Bucket
- Dish soap (a few drops) or a dedicated window cleaning solution
- Water (clean, preferably distilled for the final rinse)
- Scrubber or sponge (non-scratching)
- Extension pole (if needed for high windows)
- Ladder (for second-story windows, if safe and stable)
- Old towel or drop cloth to protect the ground
- Optional: vinegar or rubbing alcohol for hard water spots
Step-by-Step
- Prepare the area. Move any outdoor furniture or plants away from the windows. Lay a towel or drop cloth below the window to catch drips and protect the sill.
- Remove loose dirt. Use a dry brush or a hose with a spray nozzle to rinse off loose dust, cobwebs, and debris from the glass and the frame. This prevents scratching when you scrub.
- Mix your cleaning solution. Fill a bucket with warm water and add a few drops of dish soap. If you have hard water spots, add a splash of white vinegar (about 1/4 cup per gallon). Stir gently.
- Wet the window. Dip your scrubber or sponge into the solution and thoroughly wet the glass, starting from the top and working down. Make sure the entire surface is soapy.
- Scrub gently. Use the scrubber to loosen dirt, paying extra attention to corners and edges. Avoid using abrasive pads that can scratch the glass.
- Squeegee technique. Start at the top corner of the window. Pull the squeegee down in a straight, steady stroke, then wipe the blade with a clean cloth. Overlap the next stroke by about an inch, working your way down the window. Wipe the blade after each pass to avoid streaks.
- Finish the edges. Use a dry microfiber cloth to wipe away any remaining water or soap along the edges and corners where the squeegee can’t reach.
- Dry the frame and sill. Wipe down the window frame and sill with a dry cloth to prevent water spots and damage to the wood or paint.
- Repeat for each window. Work from top to bottom, and if you’re doing multiple windows, change the water when it becomes dirty.
Common Mistakes
- Cleaning in direct sunlight—the solution dries too quickly, leaving streaks.
- Using too much soap, which leaves a film.
- Not wiping the squeegee blade between strokes.
- Using a newspaper—ink can smear and the paper can leave lint.
- Forgetting to rinse the glass with clean water if you have hard water, as minerals in tap water can leave spots.
- Scrubbing with abrasive pads that scratch the glass.
Tips
- Use a squeegee with a rubber blade that is not worn or cracked; replace it if it leaves streaks.
- For very dirty windows, do a pre-rinse with a hose to remove heavy grime.
- Use distilled water for the final rinse to avoid mineral spots.
- If you have a two-story house, consider using an extension pole with a squeegee and scrubber—no ladder needed.
- Clean windows on a cloudy day or in the early morning/evening when the sun is not directly on the glass.
- For stubborn hard water spots, apply a paste of baking soda and water, let it sit for a few minutes, then rinse.
Troubleshooting
- Streaks remain after cleaning. This usually means the glass wasn’t rinsed well or you used too much soap. Re-wet the window with plain water and squeegee again without soap.
- White spots after drying. These are mineral deposits from hard water. Wipe the glass with a cloth dampened with a 50/50 vinegar and water solution, then rinse and dry.
- Squeegee leaves a film. The blade may be dirty or worn. Clean the blade with a cloth and check for nicks; if necessary, replace it.
- Soap suds are hard to remove. You used too much soap. Rinse the window thoroughly with clean water and squeegee again.
- Window is too high to reach safely. Use an extension pole or hire a professional. Do not stand on the top rungs of a ladder.
Frequently Asked Questions
- Can I use vinegar to clean windows? Yes, mix 1 part vinegar with 10 parts water for a streak-free solution, especially effective on hard water spots.
- How often should I clean the outside of my windows? Twice a year is typical, but more often if you live in a dusty area or near the ocean.
- What is the best time of day to clean windows? Early morning or late afternoon on a cloudy day, when the sun is not directly on the glass.
- Do I need a squeegee? A squeegee gives the best streak-free result, but you can use a microfiber cloth and a dry cloth in a pinch.
- How do I clean windows on the second floor safely? Use an extension pole with a scrubber and squeegee, or hire a professional. Avoid leaning out of windows.
- Can I use a pressure washer? Not recommended—it can force water into the frame and damage seals. A hose with a spray nozzle is safer.
Related
General steps for current mainstream versions; menus can differ by device and version. See the disclaimer or report an error.
More in this bed
- Set a Google Play Budget & Stop Accidental Purchases
- Destiny 2 Error Code Anteater: Fixes & Causes
- View Android Photos on Chromebook: Step-by-Step
- Fix Windows Could Not Prepare the Computer to Boot
- Windows 11 Security Settings: Best Config Guide
- Install Custom Recovery on Samsung Galaxy Trend