Face ID is a convenient way to unlock your iPhone or iPad, but when it stops working, it can be frustrating. This guide walks you through the most common causes and fixes, from simple cleaning to resetting your Face ID settings. You’ll learn how to get Face ID working again without needing to visit a service center in most cases.
What You’ll Need
- A soft, lint-free cloth (like the one used for eyeglasses)
- Your iPhone or iPad passcode
- A well-lit room (not direct sunlight)
- Patience – some fixes require waiting a few minutes
Step-by-Step
- Check for physical obstructions. Remove any screen protector, case, or camera cover that may be blocking the TrueDepth camera system at the top of the display. Even a thin film can interfere with the infrared projection.
- Clean the TrueDepth camera. Gently wipe the area around the notch or Dynamic Island with a soft, dry, lint-free cloth. Do not use water or cleaning products. Dust, oil, or makeup can block the infrared sensors.
- Make sure your face is visible. Ensure your eyes, nose, and mouth are not covered by a mask, sunglasses (unless you have set up Face ID with glasses), or a hat that sits too low. Face ID needs to see your eyes, nose, and mouth to work.
- Position the device properly. Hold the iPhone or iPad at about arm’s length, with your face centered in the frame. Make sure the camera is not too close or too far away.
- Check for software updates. Go to Settings > General > Software Update. If an update is available, install it. Software bugs can sometimes cause Face ID to fail.
- Restart your device. Turn off your iPhone or iPad, wait 30 seconds, then turn it back on. This clears temporary glitches that may be affecting Face ID.
- Reset Face ID. Go to Settings > Face ID & Passcode (enter your passcode), then tap Reset Face ID. After resetting, tap Set Up Face ID and follow the on-screen instructions, moving your head in a circle slowly.
- Set up an alternative appearance. If you wear glasses, a hat, or have grown a beard since you first set up Face ID, go to Settings > Face ID & Passcode > Set Up an Alternative Appearance. This lets you register a second look that Face ID can recognize.
- Check for hardware damage. If your device has been dropped, exposed to water, or has a cracked screen near the camera, Face ID hardware may be damaged. In that case, you’ll need to contact Apple Support or an authorized service provider.
Common Mistakes
- Using a wet cloth. Moisture can damage the TrueDepth camera. Only use a dry, soft cloth.
- Ignoring the passcode requirement. After a restart or a failed Face ID attempt, you must enter your passcode first. Face ID won’t work until you do.
- Covering the camera with a finger. When holding the device, your palm or fingers may be covering the TrueDepth camera. Hold it lower or higher.
- Setting up Face ID in poor lighting. While Face ID works in the dark, setting it up in extreme backlighting (like direct sunlight) can cause a poor scan.
- Assuming a screen protector is safe. Many screen protectors, especially those with a privacy filter or colored tint, can block the infrared projector. If you have one, try removing it.
Tips
- Face ID works best when your face is between 10 and 20 inches from the device. Too close or too far will fail.
- If you wear sunglasses, make sure they are not UV-blocking or polarized. Face ID uses infrared, and some lenses block it. You can test by trying without them.
- After a restart, you must enter your passcode once. This is a security feature, not a bug.
- If you have an Apple Watch, you can enable Unlock with Apple Watch in Face ID & Passcode settings. This lets you unlock when Face ID fails because of a mask, but it won’t fix the underlying issue.
- Keep the TrueDepth camera area clean regularly, especially if you wear makeup or sunscreen.
Troubleshooting
If you’ve tried all the steps above and Face ID still won’t work, try these additional checks:
- Check if Face ID is disabled. Go to Settings > Face ID & Passcode. If the toggle for iPhone Unlock or iTunes & App Store is off, turn it on. Sometimes a software update or restore can turn these off automatically.
- Check for a “Face ID has been disabled” message. If you see this, it means Face ID failed too many times. You must enter your passcode to re-enable it. This is a security measure.
- Restore the device via a computer. If the problem persists, connect your iPhone or iPad to a computer and use Finder (macOS Catalina or later) or iTunes (Windows or older macOS) to restore it. This will erase all data, so back up first. A clean restore can fix deep software issues.
- Check for liquid damage. If your device was exposed to liquid, the TrueDepth camera may be damaged. Look for a red or orange liquid contact indicator (in the SIM card slot on iPhones). If present, hardware repair is likely needed.
- Contact Apple Support. If none of the above works, the hardware is likely faulty. Apple offers diagnostic tools and can run a remote test. They may replace the device or the TrueDepth camera module.
Frequently Asked Questions
Why does Face ID stop working after a screen replacement?
Face ID is paired to the original TrueDepth camera. If a repair shop replaces the screen without transferring the original camera module, Face ID will not work. Only Apple or an authorized provider can properly pair a new camera.
Can Face ID work with a mask?
Yes, on iPhone 12 and later, Face ID can work with a mask if you have the latest iOS and have enabled Face ID with a Mask in settings. It scans the area around your eyes. However, it may require a passcode more often.
Does Face ID work in the dark?
Yes, Face ID uses an infrared projector and dot matrix, so it works in complete darkness. The only requirement is that your eyes are open and unobstructed.
Why does Face ID fail when I wear sunglasses?
Some sunglasses block infrared light. Face ID cannot see your eyes through them. Try removing them or use a pair that doesn’t block IR (most non-polarized, non-UV glasses work).
How many times can Face ID fail before it locks?
After five unsuccessful attempts, Face ID will require your passcode. After that, you must enter the passcode to unlock. This is a security feature to prevent unauthorized access.
Can I use Face ID with a broken camera?
No, Face ID relies on the TrueDepth camera system. If the camera is physically damaged, Face ID will not work. You’ll need to have the camera module repaired or replaced by Apple or an authorized service provider.
Related
General steps for current mainstream versions; menus can differ by device and version. See the disclaimer or report an error.
More in this bed
- Disable Autocorrect on iPhone or iPad: Quick Guide
- Restore Windows 11 Display Scaling to Recommended
- Semiconductor Cycle: How Investors Track It0.0
- Microsoft Store Error 0x80073d12: Fixes That Work
- View Notification Count on iPhone: Full Guide
- Custom Keyboard Shortcuts on Windows 11 & macOS