This guide shows you how to make a water-resistant case for your iPhone or iPad using readily available materials. It won’t turn your device into a submarine, but it will protect against splashes, rain, and accidental spills. You’ll need a few basic supplies and about 30 minutes per device.
What You’ll Need
- Clear, heavy-duty zip-top bags (gallon size for iPads, quart size for iPhones) – make sure they are new and have no holes.
- Silica gel packets (the kind that come in shoe boxes) – these absorb moisture.
- Cotton balls or a soft microfiber cloth.
- Rubbing alcohol (isopropyl, 70% or higher).
- Scissors (optional, for trimming the bag).
- Waterproof tape (e.g., duct tape or electrical tape) – optional, for extra sealing.
- A dry, clean workspace.
Step-by-Step
- Clean and dry your device. Wipe the iPhone or iPad with a dry microfiber cloth to remove dust and fingerprints. If the screen is dirty, use a tiny bit of rubbing alcohol on the cloth, but make sure it’s completely dry before proceeding.
- Prepare the bag. Open the zip-top bag and turn it inside out. Use a cotton ball dipped in rubbing alcohol to wipe the inside of the bag thoroughly. This removes any manufacturing residue and helps the bag seal better. Let it air dry completely.
- Add silica gel packets. Place 2-3 silica gel packets at the bottom of the bag. These will absorb any moisture that might get in later. For an iPad, use 4-5 packets.
- Insert your device. Carefully slide the phone or tablet into the bag, screen side facing the front of the bag (the side you’ll be looking through). Make sure the device is fully inside and the ports (charging, headphone) are not blocked by the bag’s seal area.
- Squeeze out the air. With the bag open, gently press on the device to push out as much air as possible. You want the bag to hug the device tightly – less air means less chance of water sloshing around inside.
- Seal the bag. Press the zip-top seal closed, starting from one corner and running your fingers along the entire length to ensure it’s completely closed. You should hear a click or feel it snap shut.
- Fold and secure (optional). Fold the top of the bag (the part above the seal) down toward the device, and secure it with a piece of waterproof tape. This creates a double barrier and prevents the seal from accidentally opening.
- Test it (before trusting it). Place a paper towel inside a similar bag, seal it, and submerge it in a sink of water for a minute. If the paper towel stays dry, your bag is likely good. Do this with your actual bagged device only if you’re confident.
Common Mistakes
- Using a bag that’s too big. Excess bag material creates air pockets that can trap water and press against the device.
- Not cleaning the bag. Residue from manufacturing can weaken the seal.
- Forgetting silica gel. Even a tiny bit of condensation can form inside a sealed bag. Silica gel absorbs that moisture.
- Sealing the bag with air inside. Air expands when the device warms up (like when playing a game), which can force the seal open.
- Assuming it’s fully waterproof. This is a splash-proof solution, not a dive case. Don’t take it swimming.
Tips
- Use a bag with a “double zip” seal if you can find one – it’s more secure.
- For outdoor use, put the bagged device in a second bag, sealed in the opposite direction. This is called double-bagging and provides extra protection.
- If you’re using the device for photography, cut a small hole in the bag for the camera lens, then seal the hole with a clear, waterproof adhesive film (like a screen protector). This lets you take clear photos without the bag’s plastic distorting the image.
- Keep the bagged device out of direct sunlight for long periods – the heat can cause condensation.
- Replace the silica gel packets every few months – they absorb moisture from the air and become less effective.
Troubleshooting
- The bag won’t seal. Check the zip track for any debris or damage. Clean it with a cotton swab and rubbing alcohol, then try again. If it still won’t seal, use a different bag.
- Condensation appears inside. Open the bag, dry the device and the inside of the bag with a cloth, add more silica gel packets, and reseal. This usually happens if the device was warm when you sealed it.
- Water got in. Immediately remove the device and turn it off. Do not charge it. Dry it with a cloth and place it in a bowl of uncooked rice or with silica gel packets in a sealed container for 24-48 hours. Do not use a hair dryer – the heat can damage components.
- The touchscreen doesn’t respond well. The plastic bag can interfere with touch sensitivity. Try pressing a bit harder, or use a stylus. If it’s still unresponsive, the bag might be too thick – try a thinner bag.
- The camera lens is foggy. This is usually condensation on the inside of the bag. Open the bag, wipe the inside with a dry cloth, and reseal with fresh silica gel.
Frequently Asked Questions
Can I use a regular sandwich bag?
Technically yes, but they’re thinner and tear easily. Heavy-duty freezer bags or zip-top bags are much more durable and provide better protection.
Will this make my phone fully waterproof?
No. This method is water-resistant, not waterproof. It will handle splashes, rain, and brief accidental submersion, but it is not safe for swimming, showering, or underwater photography.
Can I still use Face ID or Touch ID?
Face ID may have trouble seeing your face through the plastic. Touch ID might work if the bag is thin enough, but it can be unreliable. You may need to use your passcode instead.
How long can I keep my device in the bag?
For short periods (a few hours) it’s fine. For longer periods, condensation can build up. Check the device periodically and open the bag to let it breathe.
Will the bag scratch my phone?
If the bag is clean and dust-free, it won’t scratch. That’s why cleaning the inside is important. If you’re worried, put a screen protector on your phone first.
Can I use this for other electronics?
Yes, this method works for any small electronic device – cameras, GPS units, e-readers, etc. Just make sure the device fits comfortably in the bag without stretching it too much.
Related
General steps for current mainstream versions; menus can differ by device and version. See the disclaimer or report an error.
More in this bed
- Schedule Tweets on X (Twitter) Web App
- Fix Standby Mode Not Working on iPhone
- Madden 19 Crashing on PC: Fixed
- macOS Sierra USB Installer: How to Make One
- Fix System PTE Misuse BSOD on Windows
- PlayStation Games Still Physical After Store Closures