Drafty windows and doors can make your home feel colder, increase heating bills, and reduce comfort during winter. This guide shows you how to identify and seal air leaks using simple materials and tools. Before starting, gather your supplies and inspect all windows and doors for visible gaps or cracks.
What You’ll Need
- Caulk (silicone or acrylic latex) and a caulking gun
- Weatherstripping (foam tape, V-strip, or felt)
- Door sweep (with screws or adhesive)
- Expanding foam sealant (for larger gaps)
- Utility knife or scissors
- Cleaning cloth and mild detergent
- Putty knife or flat screwdriver (to remove old caulk)
- Flashlight (to detect drafts)
- Incense stick or candle (to locate leaks)
Step-by-Step
- Inspect for drafts: On a windy day, hold a lit incense stick or candle near the edges of each window and door. If the smoke or flame flickers, there is a leak. Mark the spots with painter’s tape.
- Clean the surfaces: Wipe down the frames, sashes, and thresholds with a mild detergent to remove dirt and old adhesive. Dry thoroughly before applying anything.
- Remove old caulk or weatherstripping: Use a putty knife or screwdriver to scrape away cracked caulk and worn weatherstripping. This ensures a clean surface for new material.
- Caulk stationary gaps: Apply a bead of caulk along the seams where the window frame meets the wall, and where the sill meets the frame. For doors, caulk the exterior trim where it meets the siding. Smooth the bead with a wet finger or tool.
- Install weatherstripping on operable parts: For windows, apply self-adhesive foam tape or V-strip along the sides and top of the sash so it compresses when closed. For doors, apply weatherstripping to the top and sides of the door frame, not the door itself.
- Install a door sweep: Measure the width of the door, cut the sweep to fit, and attach it to the bottom of the door (inside side) using screws or adhesive. It should touch the threshold lightly when the door is closed.
- Fill larger gaps: For gaps wider than 1/4 inch, use expanding foam sealant. Spray a small amount into the gap, let it expand and dry, then trim the excess with a knife. Do not use foam on window sashes or door frames that need to move.
- Check for air leaks again: Repeat the incense test to confirm the drafts are gone. Pay attention to corners and hinges.
Common Mistakes
- Using caulk where weatherstripping is needed: Caulk hardens and prevents windows from opening or closing. Use it only on non-moving parts.
- Applying weatherstripping to a dirty surface: Adhesive won’t stick to dust or grease. Always clean and dry the surface first.
- Choosing the wrong type of weatherstripping: Foam tape works for irregular gaps, but V-strip is better for sliding windows. Felt is less durable. Match the material to the gap size and movement.
- Forgetting the threshold: A gap under the door is a major leak. A door sweep or threshold replacement is essential.
- Overfilling gaps with foam: Expanding foam can warp frames if too much is used. Apply in small amounts and let it expand.
- Ignoring the attic or basement: Drafts often come from above or below, not just windows. Check for leaks around pipes and vents.
Tips
- Do this before winter, when temperatures are mild, so caulk and adhesives cure properly.
- Use a caulk with a flexible formula (silicone) for areas that expand and contract with temperature changes.
- For double-hung windows, place weatherstripping on the top of the upper sash and the bottom of the lower sash to seal both.
- Consider clear plastic film kits for very old windows that still leak after sealing.
- Check the condition of your window locks – they often pull the sash tight, reducing drafts.
- If you have a fireplace, make sure the damper is closed and sealed when not in use.
Troubleshooting
Draft persists after sealing: The leak may be behind the trim or in the wall. Check for gaps in the exterior siding or around the window frame. Use expanding foam in the gap between the frame and the wall, but only from inside if you can access it.
Weatherstripping won’t stick: Clean the surface with rubbing alcohol, let it dry completely, and apply in temperatures above 50°F (10°C). If it still fails, use a stronger adhesive or mechanical fasteners.
Door sweep drags on the floor: Adjust the height or trim the sweep so it just touches the threshold. If the threshold is uneven, consider a door shoe with a flexible bottom.
Window still rattles: Add a small piece of foam tape in the track to cushion the sash, or tighten the hardware.
Caulk cracks within a month: The surface may have been damp or dirty. Remove the old caulk, dry thoroughly, and reapply. Use a high-quality exterior-grade caulk.
Foam sealant expands too much: Trim the excess with a knife, but do not paint over it unless it is labeled paintable. For future, use a low-expansion foam.
Frequently Asked Questions
Q: How do I find drafts without an incense stick?
A: Hold a piece of tissue or a thin plastic bag near the edges – if it moves, there’s a draft. A flashlight can also reveal gaps when held against the frame from the other side.
Q: What is the best type of weatherstripping?
A: V-strip (vinyl or metal) is durable and works well for windows and doors. Foam tape is easy to install and good for irregular gaps, but it may need replacement every few years.
Q: Can I use duct tape to seal drafts?
A: Duct tape is not a long-term solution. It degrades with temperature changes and leaves sticky residue. Use proper weatherstripping or caulk.
Q: Should I caulk the inside or outside of the window?
A: Both, but focus on the exterior to prevent water damage. Inside, caulk only if there are visible gaps to the outside. Avoid caulking the sash tracks.
Q: How often should I replace weatherstripping?
A: Check annually before winter. Foam tape may last 1-2 years, while V-strip and metal can last 5-10 years. Replace when it becomes brittle or compressed.
Q: Will sealing drafts really save money?
A: Yes, reducing air leaks can cut heating costs by 10-20% according to energy efficiency guidelines. The savings depend on your home’s age and climate.
Related
General steps for current mainstream versions; menus can differ by device and version. See the disclaimer or report an error.
More in this bed
- Zoom on iPhone & iPad: Host or Join a Meeting
- Fix iPhone SE 4 Unable to Activate: Step-by-Step
- Keep Important Emails From Getting Buried in iPhone Mail Categories
- How to Clear RAM on iPhone: Speed It Up
- MacBook Charger Not Working? Fix It Now
- Fix Windows Cannot Be Installed to This Disk