sodcalculator

10 Tech How-To

How to Recover Photos from a Water Damaged iPhone 6s

Guide 10-56527 · Updated · Step by step

Dropping your iPhone 6s in water is a stressful moment, especially when your photos are on it. This guide walks you through the steps to maximize your chances of getting those pictures back, from immediate first aid to software recovery and professional options. Before you start, stop using the phone entirely and do not plug it in to charge—powering a wet phone can cause a short circuit that permanently destroys the logic board.

What You’ll Need

  • A soft, lint-free cloth (microfiber works best)
  • A small Phillips screwdriver (for the pentalobe screws on the bottom—check which type your phone has)
  • A suction cup (optional, for opening the screen)
  • A plastic spudger or guitar pick (for prying)
  • Silica gel packets or uncooked white rice (as a desiccant)
  • A computer with iTunes or Finder (for backup recovery)
  • A USB cable (only after the phone is dry)
  • Optional: a third-party data recovery tool (like Dr. Fone or PhoneRescue)

Step-by-Step

  1. Remove the phone from water immediately. The longer it sits, the more corrosion spreads across the internal components. Pull it out and turn it off right away if it is still on. Do not press any buttons—even the home button—unless absolutely necessary to power it down.
  2. Do not charge it. Plugging in a wet phone sends current through moisture, which can short-circuit the logic board. Keep it unplugged until you are confident it is completely dry inside.
  3. Wipe the exterior dry. Use a soft cloth to remove all visible water from the screen, back, and edges. Pay attention to the charging port, headphone jack, and speaker grilles—gently dab these areas; do not insert anything into them.
  4. Remove the SIM card tray. This opens a small gap that lets water escape and air in. Take the SIM card out and dry it separately.
  5. Do not use a hair dryer or heat gun. Heat can warp the adhesive that seals the screen and battery, and it can melt internal components. Let the phone air dry naturally.
  6. Place the phone in a desiccant. Put it in a sealed container with silica gel packets if you have them, or a bowl of uncooked rice. Rice works but silica gel is more effective. Leave it there for at least 48–72 hours. Do not be tempted to check it sooner—every time you open the container, you let moisture back in.
  7. After drying, try turning it on. If it powers up, immediately back up your photos to iCloud, Google Photos, or a computer. If it does not turn on, move to the troubleshooting section below.
  8. If the phone turns on but the screen is unresponsive or black, try connecting it to a computer. Sometimes the display fails but the storage is still readable. Use iTunes or Finder to see if the device is detected. If it is, you can try a backup or use a third-party tool to extract photos directly from the device.
  9. If the phone is dead but you have a previous iCloud or iTunes backup, recover from that. On a new or repaired phone, restore from the backup. Note that any photos taken after the last backup will be lost.
  10. If all else fails, seek professional data recovery. A specialist can open the phone, clean the corrosion, and often read the flash memory directly. This is expensive but is the most reliable last resort.

Common Mistakes

  • Trying to charge it while wet. This is the single biggest cause of permanent damage. Even if the phone appears dry on the outside, moisture inside can short the battery contacts.
  • Using a hair dryer, oven, or microwave. These introduce heat that can melt adhesives, warp the chassis, or damage the battery, creating a fire risk.
  • Pressing buttons repeatedly. Every press sends a signal through the device, which can cause a short if water is still inside.
  • Opening the phone without the right tools. Prying too aggressively can tear the display cables or damage the home button flex cable. If you are not comfortable, skip this step.
  • Waiting too long before professional help. Corrosion begins within hours. If the phone does not dry out and turn on within a few days, do not wait weeks to seek help.
  • Assuming rice is a miracle cure. Rice absorbs some moisture, but it also leaves dust and starch inside the phone. Silica gel is much better.

Tips

  • Keep your phone in rice or silica gel for a full 72 hours. Even if it seems dry after 24 hours, moisture can linger deep inside the logic board.
  • If you open the phone, disconnect the battery first. This stops any current from flowing and reduces the risk of a short circuit. You can find detailed teardown guides online with photos.
  • Use isopropyl alcohol (90% or higher) to rinse corroded areas. If you open the phone and see white or green residue, gently clean it with a soft brush dipped in alcohol. Alcohol displaces water and evaporates quickly without damaging components.
  • Back up to the cloud regularly. iCloud Photo Library, Google Photos, or a local backup to your computer means you never lose more than a few minutes of photos, even in a worst-case scenario.
  • Try a third-party recovery tool before giving up. Programs like iMazing or PhoneRescue can often read the phone’s storage even when the screen is dead, as long as the phone is recognized by the computer.
  • Keep the phone in a dry, cool place while waiting. Avoid leaving it in a hot car or near a radiator.

Troubleshooting

Phone does not turn on after drying. This is common. Try connecting it to a computer via USB. If the computer makes a chime or shows an unknown device, the phone is communicating—your data may still be accessible. Use a third-party recovery tool to attempt a direct read.

Phone turns on but the screen is black or has lines. The display may be damaged, but the logic board could be fine. Connect to a computer and see if iTunes/Finder recognizes it. If yes, back up immediately or use a recovery tool. You may also need a screen replacement before you can use the phone normally.

Phone turns on but shows the “connect to iTunes” screen. This indicates a recovery mode loop, often caused by water damage. Try updating (not restoring) via iTunes/Finder first—this may preserve your data. If that fails, you may need to restore, which will erase the phone.

Phone is recognized by computer but backup fails. The storage may be partially damaged. Try a third-party tool that can read the raw filesystem. If that fails, professional recovery is your best bet.

You have no backup and the phone is completely dead. Do not attempt to open it yourself unless you are experienced. A professional data recovery service has clean-room tools and can often recover photos even from water-damaged flash memory. The cost is high (often hundreds of dollars), but it may be worth it for irreplaceable images.

You see corrosion on the battery connector. If you opened the phone and see green or white crust, do not try to power it on. Clean the area with isopropyl alcohol and a soft brush, let it dry, then try again. If the battery is swollen or damaged, replace it before attempting to power on.

Frequently Asked Questions

Can I recover photos from a water-damaged iPhone 6s that won’t turn on?
Yes, often you can. The flash storage chip is usually the last component to fail. A professional can remove the chip and read it directly, or a third-party tool may be able to access it if the phone is recognized by a computer.

Is it safe to put my iPhone in rice?
It is a common home remedy, but not ideal. Rice can leave dust and starch inside the phone, and it is less effective than silica gel. If you have no silica gel, rice is better than nothing, but remove the phone after 72 hours and clean any residue.

How long should I wait before trying to turn on my iPhone?
At least 48 hours, ideally 72. Water trapped under chips or in connectors takes time to evaporate. Turning it on too early can cause a short circuit.

Will Apple recover photos from a water-damaged iPhone?
Apple does not offer data recovery services. They may replace the phone for a fee, but your data will be lost. You would need to use a third-party professional service.

Can I use a hair dryer to dry my iPhone faster?
No. Heat can damage the battery, screen adhesive, and internal components. It can also push water deeper into the device. Air drying is the only safe method.

What if my iPhone turns on but the touch screen doesn’t work?
Your photos are likely still safe. Connect the phone to a computer and use iTunes/Finder to back up, or use a third-party tool to extract photos directly. You can then restore the backup to a new phone.

Related

General steps for current mainstream versions; menus can differ by device and version. See the disclaimer or report an error.

More in this bed

The whole Tech How-To bed →